Parting Beads

Removing & installing sash, temporary boardup, frame & sill repairs, wall sealing, frame & trim painting.
johnleeke
Site Admin
Posts: 150
Joined: Thu Aug 29, 2013 8:21 pm
Interests:
Location: Portland, Maine, USA
Contact:

Parting Beads

Postby johnleeke » Wed Feb 08, 2017 5:47 pm

I always saving parting beads when in good condition and it costs less than replacing, which is about half the time.

Making Parting Beads
To get a nice press fit I use vernier calipers to measure the old beads to the nearest .01" and make the new ones at the table saw to match at the same tolerance. Nice press fit every time.
For one-offs I keep a small supply of slightly varying sizes. That supply is usually left-overs, I always make a couple extra when I have to make some.

For an easy installation bevel the two back arrises with sandpaper.

Return to “Site Work”

Who is online

Users browsing this forum: No registered users and 1 guest